This firmware is intended only for Chroma-Q Space Force

To install the firmware, a Chroma-Q UploaderII will be needed.

The engine firmware can only be updated by a Service Centre approved by Chroma-Q.
Note: There are two firmware files per fixture: 1 for each of the engine boards and 1 for the addressing board. The order of the updates is not important. 
If updating more than one fixture, they must be done one at a time. Attempts to update several fixtures at once will corrupt the firmware. 

The engine with 901-0238 RevD is named as EngPcbRev_D. The engine with 901-0238 RevE is named as EngPcbRev_E.

Engine Firmware version: 3.3.2
- File Name: SpaceForce_EngPcbRevE_FirmwareV3.3.2.bin
- Release Date: 2021-10-19
- Compatible Engine PCBs: All
- Compatible Units: All
- Changes since the previous V2.0 release:
	1. Adjust Fading steps and timing to match Engine_Rev_D type units.
	2. Support at run time for Engine_Rev_D and Engine_Rev_E type 
		Note, Engine_Rev_D and Engine_Rev_E cannot be mixed on the same physical fixture
	3. Implemented hardware Revision ID detection.
	4. Remove brief blackout upon PWM frequency change
	5. Add frequency change filter (300 msec) 
	6. Fit dimming tables to match Engine_Rev_D type hardware.
	7. Adjust fading steps and timing to match Engine_Rev_D type units.
	8. Finalized dimming tables based on latest hardware


Engine Firmware version: 2.0
- Release Date: 2016-01-01
- Compatible Engine PCBs: To be used **only** with Engine PCB 901-0238 RevD
- Compatible Units: Use this firmware on units with the following Serial Numbers:
    	- Model 650-1000 - SN: 0306245288 or lower
    	- Model 650-1500 - SN: 0306250034 or lower



Addressing Board Firmware Version: 1.7
- File Name: SpaceForce_AddPcbRevC_FirmwareV1.70.bin
- Release Date: 2019-01-16
- Changes since the previous release:
	1. Added Personality selection, save and restore user defaults to the main menu. Two personalities are implemented:
		a. INT-CCT: 
			i. Footprint: Two channels (Address, Address+1).
			ii. First channel: Light intensity; Second channel: Light temperature
		b. INT-CCT-EXTD:
			i. Footprint: Three channels (address, address+1, Address+2).
			ii. First two channels are similar to (a.); the third channel is the Control (CTRL) channel. Commands (through DMX) that are placed on this channel for over 5 seconds get executed. The command list will follow in the “New Control via DMX” section. 
	2. Added “RDM” to Technical menu: RDM “Enable” or “Disable” switch.
	3. PWM default frequency:  set to 3000 Hz.


For any additional info, contact us at info@chroma-q.com